How do you remove a Craftsman riding mower deck?

Placing your equipment at an angle or tipping it on its side can coat the spark plug with oil, which ruins the plug and prevents it from sparking. Tipping a mower can also allow oil to leak and clog the air filter, or mix in with the fuel.

How to Remove the Deck From the Craftsman YTS3000

  1. Park the mower on a flat, hard surface.
  2. Press the clutch/brake pedal down completely and set the parking brake.
  3. Disconnect the spark plug wire from the spark plug, located near the front of the engine.
  4. Move the attachment lever to the lowest position to lower the mower completely.

Beside above, can you tip a riding lawn mower on its side? Placing your equipment at an angle or tipping it on its side can coat the spark plug with oil, which ruins the plug and prevents it from sparking. Tipping a mower can also allow oil to leak and clog the air filter, or mix in with the fuel.

Similarly, how do you take the wheels off a Craftsman riding lawn mower?

Slide the washer and retaining ring off the axle. Grasp the square key behind the wheel on the axle with needle-nose pliers and pull it straight up to remove it. Only the rear wheels have a square key to lock the rear-wheel drive transmission in place so the lawn mower can move.

Are Craftsman lawn mower blades reverse thread?

Craftsman lawn tractor 42″ cut with two blades and I am not sure the age but it is over 6 years old. No, the threads are normal (right to tighten, left to loosen) threads.

What size belt goes on a Craftsman 42 inch deck?

CRAFTSMAN 42″ 144959 KEVLAR DECK BELT,SIZE : 12″ X 95″

What size belt goes on a craftsman lt2000?

42″ Blade & Belt Combo Fits Craftsman LT2000.

How do you remove a deck from a Scotts riding mower?

How to Remove the Mower Deck on a Scotts S2046 Lawn Tractor Park the mower on a flat surface and stop the engine. Slide two, 2-by-4 wood blocks under each side of the mower deck. Locate the belt guide next to the pulley behind the left front wheel on the mower deck. Locate and remove the spring locking pin and washer that hold the tension rod onto the blade drive arm.